Question by Dave S: question for Peugeot 206 owners / mechanics?
I own a peugeot 206 gti, Recently a fault light is fashing saying air pollution fault? What does this mean and how to I fix it? Also how do I take off the front bumper?
thanks
Best answer:
Answer by orb
the warning light would be your lanba sebsor which proberbly need replacing but check the lead and terminals for damages from exhaust down pipe going to the to of the engine on the right of the cylinder head . bumper easy
1 lift bonnet
2 remove plastic pegs from finger grill ( black ones lift the middle part up )
3 pull away from bonnet catch area put hand behind locate clips which attach to front grill
4 there are 6 ,3 on either side squeeze flaps to release this is tricky take care not to break, remove finger grill
5 with it so far
6 take a t30 screw driver is the correct size but a small flat head will fit unscrew centre fixing for front grill a little an remove the ones attaching to the corner of the lamps
7 attaching the front grill to the head lamps is a small insert peg this is flat an is located right in the corner of the lamp nr indicator behind the lamp put your finger under an lift gently whist pulling centre of grill this will release again carefull not to damage
8 now the front grill is attached to the wings by two spear shaped clips on either side easiest way to remove is with a rounded flat screw driver pull the gril towards you an insert the tool behind the plastic in the middle of the two clips take care to get the toolbehind the grill so any slight dam is hidden when replaced now just pull it sharply (got it of ?)
9 you will need ten ml socket , t20 or small screww driver t30
10 under front bumper remove ten ml nuts two of gold coloured most likly remove four t 20 screws which attach to mud shields then unclip fogs terminals sqeeze the metal bar inwards to release
11 look a mud shields remove black peg clip as on the finger grill youll only need to loosen mud shields enoughso you can get your hand in up an behind the wing look under head lamp an locate 10 ml attaching wing an bump remove 1 on either side place tape on bolt to save damage to outer wing paint work(your nearly there )
now ther are 3 t30 screws on top of rub strip a centre one an one under each lamp decide if you want to loosen headlamps to reach the two i find if you got a t30 bit you know the interchangable kind its just the end bitplace this in screw hold in place with figer (you should have enough room)
plyers if you loosen enough you can then remove with fingers this could be tricky if your first attempt but save taking headlamps out .
12 remove centre t30 and bumper will fall of in your hand
hope you followed that
Give your answer to this question below!
Recent Comments